Welding Exhaust Bungs - Where to go?

[Brizzman]

I got a new exhaust for my Warrior 1700 and want to get 2 bungs welded in for some O2 sensors. Who in town does good work and can do it soon? I had a guy set up to do it, but it's it keeps getting put off and I want it done.

Who do you guys suggest?

Here's the new pipes on the bike.

 

[CashMoney]

I would mark where you want the bungs to be then pull the pipes off. That's a super easy job.

 

[Brizzman]

It is a VERY tight fit for the front sensor. I'm not sure that just marking it would be precise enough. I took it to Ace cycle yesterday. He can do it, but not until next week (after Street Vibrations). I was hoping to get it done sooner, but it ran fine riding down to Ace, so I guess I can wait.

 

[RARECJ8]

Only guy i trust. The original mr z.

https://www.mapquest.com/us/nevada/zambonis-muffler-10722361

 

[Norm the Big]

Take it to Eric aka Dr. Smash fabrication. Hes done lots for me.

 

[turbobrick]

Take it to Eric aka Dr. Smash fabrication. Hes done lots for me.

I sure hope the OP got this sorted out back in '17.